Posts

Chosen Solution When I vacuum a whole room the canister is empty. But the floor is somewhat clean If your Shark Navigator Lift-Away Pro no longer sucks up dirt, dust, and debris, see the Shark Navigator Lift-Away Pro Loss of Suction problem page for possible causes and solutions. If your Shark Navigator Lift-Away Pro no longer sucks up dirt, dust, and debris using the vacuum’s nozzle, see the Shark Navigator Lift-Away Pro Loss of Nozzle Suction problem page for possible causes and solutions....

Chosen Solution I have imac 2006 17 inch was in it processor intel core 2 duo T5600 I replaced it with intel core 2 duo T6300 and imac turns on for 2 seconds and immediately turns off on the board there are 3 diodes first lights up and when I turn on imac the second one lights up but imac turns off and she goes out please help i don’t know what to do with it...

Chosen Solution My screen is not rotating when flipped back into the camera, it’s stuck upside down. @aprice10 you did not tell us if it still shows everything appropriate just upside down. Let us know if the menus are also upside down. If it Looks right side up when the LCD is flipped out to the left side of the body but upside down when folded back it is most commonly an issue with the orientation sensor....

Chosen Solution It’s been a couple of years and I’m not a techie so bear with me. My battery was dying so I replaced the battery. I also ordered a SSD to replace my HD but I didn’t replace the SATA cables, and I expanded my RAM to 16 GB. My system specs are: processor: 2.3 GHz Intel Core i7memory: 16 GB 1600 MHz DDR3graphics: Intel HD Graphics 4000 1536 MBTrim support = yes Battery says: Charge Information: Charge Remaining (mAh): 3836 Fully Charged: No Charging: No Full Charge Capacity (mAh): 5252 Health Information: Cycle Count: 81 Condition: Service Battery Battery Installed: Yes AC Charger Information: Connected: No (plugged in) Charging: No (battery icon shows it’s charging) My battery has never said it was fully charged even when it showed 100%....

Chosen Solution I was replacing the screen of my Ipod 5 (16GB, no camera) when i was done the screen was perfectly working i was about to put everything together then suddenly it went black.The screen still brightens up but all i see is black and i also cant reset it because the home button doesn’t work. How can i make the screen go back to its normal self? When you took off the sceen you might have damaged the connection to the display....

Chosen Solution Hello everyone, My MBP after 6 months from purchase had a very small segment of touchbar going off (touch was still working in that area): Before bringing it to Apple Care, it magically went back to normal so I just forgot. Now, 5 months after out of warranty, a larger part of the touchbar is off, with touch still working.. Do you think I could try to check some cables or similar inside the Mac before giving up and prepare to spend a lot of money?...

Chosen Solution Hi, my mid 2014 Pro stopped registering mouse clicks on the trackpad. I then tried a USB mouse but the same happened there. Both trackpad and mouse can move the mouse and I can use mouse keys “I” to navigate the mac. I have checked the trackpad connector on the inside and it was a bit loose but after properly seating it there were no change in performance. I’ve also checked the batteries but they don’t seem swollen....

Chosen Solution I can see all my pictures from yesterday when I review them when the SD card is in the camera, but when I place the SD card in the drive in the laptop some are missing. Please advise on how I can transfer all. Thank you. Don My guess is you have some pics in your built in memory. This camera has a rare feature, 200MB of built in memory....

Chosen Solution Is there a way to get the photos off of the phone since I can no longer see the screen display? How can I get the phone to connect to a computer to transfer the photos over? The phone powers on with sound and I can swipe to unlock the phone, but I can’t see anything on the screen. so with most android phones you should be able to plug your cable into the PC and just use it like an external drive....

Chosen Solution iPhone 7 Plus SIM tray will not eject using a SIM card eject tool or a paper clip. Applying a considerable amount of force does not produce any indication that the tray will eject. The tray is flush with the device and there is no bend to the device body. Paperclip can be inserted ~4x further into the SIM tray eject hole when compared to an iPhone 7 with functional SIM tray ejection....

Chosen Solution My Lenovo tablet model TB-x103f it started going through a cycle of reboot loops. It will continue to do this until the battery dies. I looked at the recovery logs and it mentioned that it __bionic_open_tzdata: couldn’t find any tzdata when looking for localtime! I’ve went in and reset it to factory default cleared the cash. I encountered the same problem after a failed system update. Only way to fix was reloading the firmware over USB cable using ADB and FASTBOOT....

Chosen Solution Hi everybody, My 2017 21.5” iMac 4K has serious logic board problems for about an year now. At the beginning things were tolerable but now the freezes, the inability to turn on the computer except after doing about 10 on/off cycles are making it almost unusable. I’ve diagnosed it and it seems I have to replace the logic board. I don’t want to spend more than the computer cost on the new logic board and they are difficult to find anyway....

Chosen Solution out going and incoming calls are working but the voice out put is not working It’s definitely in your handset. Either someone pulled a prank and put tape or something over the receiver (I’ve responded to way to many calls where the user was pranked) or the receiver has broke lose which requires replacement. If replacement isn’t an option you can open up the handset, find where it’s broken and solder it back together....

Chosen Solution I have a MacBook pro 15* Unibody Early 2011. I have had numerous graphics problems with it, I believe the solution to it is this: http://www.apple.com/uk/support/macbookp… I handed my macbook to Humac.dk, a 3-part Preimun retailer. Humac found a VST failure, which fits very well with the problem stated above. At the same time as they found the VST failure they also found that a chip on the logic board was missing its shield and had some corrosion on it, SEE PICTURE the chip is in the lower left corner next to the fan....

Chosen Solution My iPod Touch 3G 32 Meg was on the kitchen counter and got wet when the dishes were washed. Everything works ok except the touchscreen! Can anyone recomend what I need to do to fix it? Or recommend a reliable,inexpensive repair service center. thanks I would not go that far an thay that everything is ruined. there are a few things to do when a device like that has a fluid damage....

Chosen Solution I have an iPhone SE with a broken back glass piece (top). There is some kind of flex cable underneath where the glass is supposed to be. Any ideas to what this can be? It’s an antenna for wifi and carrier wireless. Yup, as the guy above said it’s mainly your WiFi antenna, that is if your talking about the back of the phone at the top. If that’s the case I’d replace it and make sure it’s all sealed up before any dust, dirt etc get inside....

Chosen Solution I dropped my phone on the floor from a slight height. The front glass and screen are completely intact, ie no cracks or chips. But there are light white horizontal lines throughout the screen, not very visible. After a few mins, the top right corner has started becoming dark blue. WHat do I need to replace, the screen or the LCD or something else? I read a lot of answers but none of the descriptions matched mine....

Chosen Solution how can i fix this isssue Hola heyhoy52 ¿cómo estás?, I’m from Colombia and I hope your okay, first of all happy new Solar Cycle. Probably what’s causing your issue is the connection between the cables and the PCB (the board), so I strongly recommend you to chek this, look at the picture please. If it’s necessary cut the first 5 or 8 millimeters of the cable and solder to the PCB again....

Chosen Solution So I somehow lost the screws for bottom casing on my late 2016 macbook pro. Does anyone know what kind of screws it uses/where I can purchase them? Thanks! Did you try going to the Apple Store? You should be able to get them replaced for free if they fell out on their own (one or two). If you popped the bottom off to look around and misplaced them thats a bigger problem ;-{ So far I haven’t seen any parts available yet as the system is so new - Sorry

Chosen Solution my acer screen is broken. I need to replace it, where can iget one. This is the cheapest listing for US sellers on eBay. I don’t know the exact model you have so you may need to do a search on eBay with the full model number (i.e. 532H-XXXX). It is also best to actually get the LCD part number from the back of the panel and search by that number....