Posts

Chosen Solution Lg v500 tablet died after battery replaced. Can you recommend a repair facility? @drivesansvx this is a very difficult question to answer. We do not know where you reside and what exactly you are looking for in a repair facility. I suggest you use the search engine of your choice and make determination based on other customers satisfaction. I would be wondering who replaced the battery, why was it replaced and if everything has been properly reconnected....

Chosen Solution Hello dear please I want ask about my laptop problem , So when I want to power on its not work as well as its not do charging any not see any indictor to indicat about working laptop and charge? regards @othma start by checking your power supply. Measure the output of the power supply and you should get 20VDc on it. If that is okay check your charging port to make sure it is in good condition....

Chosen Solution On a keypad, the strip right over the 123 doesn’t work right. It glitches out when my finger goes across it while scrolling. It also spazes out when I hit 3 on my passcode and starts hitting delete. I dropped it in water and put it in rice, and the screen is also cracked. Is there a way I can fix this or do I just need a new phone?...

Chosen Solution I have just replaced the screen assembly on my iPhone 4 Verizon, and the touch digitizer does not work. What did I do wrong? The 2 most common things that go wrong is you bought a bad screen from a bad source,(EBay), or the Ribbon cables were damaged when you threaded them through the mid frame, also sometimes the cables dont get plugged into the logic board correctly, start there, if you need a new screen get one from ifixit or here, https://www....

Chosen Solution Touch screen non responsive? Home button works. Connection is locked in but no touch response. Do I need a new screen that I received from your business. Coast212001@yahoo.com I would suggest opening your iPad back up again and disconnecting the display and the battery. You do not have to fully take the battery out, just disconnect it from the connection port. Allow these to be disconnected for 10 seconds then reconnect....

Chosen Solution Model # LS24TDNSUV/ZA Can this be repaired? Hi @karenann , It most probably can be repaired but you’ll have to provide more information to get a better answer as to what the problem might be. Have you checked the power outlet that the TV is connected to, to ensure that it is supplying power OK, e.g. by plugging in another appliance such as a hair dryer etc? Is the TV standby light ON or OFF on the TV?...

Chosen Solution Can’t open settings..when I try it says unfortunately your touch wizard has stopped @Anton Berggren If you have a Galaxy Tab 3 10.1 try starting the tablet in safe mode and then see if you can navigate to Settings > Applications > Application Manager > swipe right to the All screen > scroll down to find and tap Touchwiz > tap Clear cache > tap Clear data, then OK....

Chosen Solution someone broke some kind of plasic roller assembly while removing a toner. I cannot find a part name or description on line. It is about 8 inches long and sits in front of and above the toner as you look into the unit. Do you know where I could get the part? It is called the paper exit guide and for some reason I am being told that it only comes with the purchase of a fuser....

Chosen Solution I do not see a water filter on my K2.0-400 but the display is telling me to change it Here’s a video on how to do it: https://www.youtube.com/watch?v=eTAYD_Rl… old question but just for completion sake @legend147 you may not have that filter as an accessory. Your brewer will indicate “Time to replace the Water Filter.” after every 1,000 ounces or two months. You can disable the water filter reminder in the settings menu....

Chosen Solution I just got a Victrola 8-in-1 only in May. Now the turntable will not turn. I have followed all the troubleshooting tips barring taking it apart to look at the motor or belt. I never had this problem until I played a 45. When I tried to play an LP the next day (today), the turntable would not turn. Brand new! Power is fine and I tried the screw adjustment tip....

Chosen Solution Plug phone in charge don’t show charg er light and want charge or anything no water damage screens not cracked or anything u need a new micro usb charging port. Try a different charging cable if that doesn’t work clean the charging port and have a look for any bent pins on the port. It could be the battery has died or charging port dirty or faulty. Get a battery try that if that doesn’t work you will need a new charging port...

Chosen Solution i replaced the dogs already but the agitator just spins and makes a noise. When i pull up on the agitator the noise stops and it begins to agitate but then stops when i let it go Cause 1 Drive Block or Bell The drive block connects the washer transmission to the agitator. If the drive block is worn out, the transmission shaft will still move back and forth, but the agitator will only move slightly or will not move at all....

Chosen Solution A part of my Nerf N-Strike Elite Retaliator broke. Does somebody now were I can buy Nerf N-Strike Elite Retaliator parts? Hi, I would recommend trying to check this.

Chosen Solution I am in pakistan.. the things they are using are not easily available here so can someone tell me what are the possible altenatives for these devices adnan maqsood, there really is not much of an alternative. You will need the heat gun for a “reflow” thermal paste and the thermal pads. If you can tell us what part you can not get, may be we can help you source it....

Chosen Solution I have an apple watch 3 series I’m not sure what to do with this piece { Series 3 GPS) Force Touch Sensor Adhesive Gasket } I replaced my screen and the seal and it works great , but my screen is a little loose on one side .Is this what this piece is for ? What would it do to the seal if I had to take the screen off again ?...

Chosen Solution I am using an Atheros AR5BXB72 Wi-Fi card that I pulled out of a MacBook Pro so I can use my Dell E6430 to get 5Ghz Wi-Fi. When hooking up the antennas, I noticed that the card itself didn’t have any color coding and had numbers on it. My laptop color-coded the antenna cables. I was wondering if there was a specific way that I should connect the antennas....

Chosen Solution i have gotten an iphone from a flee market for 10 bucks. it is a sprint iphone i have at&t. How do i make it work with my contract? can i switch a part out? Ask Sprint to unlock it or pay for a third party to do so.

Chosen Solution i was replacing my galaxt s4 charger port and i noticed that the wire cable that goes to bottom left of the charger port is broke. the left meaning when the phone is face down and trned over on its back looking at it. where could i get this pink replacement wire at. i also need the metal bracket that holds the charger port in place also. thanks and let me know where i can get these pieces!...

Chosen Solution Hi, somehow one of the pentalobe screws got lost of my Apple Watch third party leather band. Where can i purchase new screws? Hi rick Here you can find the screw you need and how to measure it http://www.laptopscrews.com/Sizing.htm your not going to be able to find pentalobe screws easily because it’s apples thing so I would go for these small screws instead one of them should work.

Chosen Solution Where is the antenna located in the LG VELVET hi, anyone know where is the cell antenna are located in the LG VELVET? or what is the specific use of each one thx Mise à jour (08/02/2022) here is the case antenna Mise à jour (12/02/2022) here the connection of antenna and where is the ipex connection it is for cell antenna extention? my goal is add external antenna to get better reception...