Posts

Chosen Solution . Please save my tv susan Parker that looks like a bad panel. “Any horizontal lines. The gate drivers are activated by a single source of timing information so any single horizontal line or groups or random horizontal lines are caused by an output failure from a gate driver or a loss of the tab bond to the panel.” If it would only be the vertical lines thatn I’d go with a failed T-con board, but since " the TCON disperses the pixel data to groups of line and column drive IC’s situated on the outer edges of the panel, it is unlikely that more than one of these IC’s would fail at the same time....

Chosen Solution What grease should be used for the lower gearbox that turns the mixing paddles? Hey mate, what you need is a food grade grease. Something like this is what you need: https://www.amazon.com/KitchenAid-Stand-… Hope this helps.

Chosen Solution Does anyone know what this is??? It’s just a perfect bar across my TV screen and it’s driving me nuts! I’m used to the normal pixel dying but I’ve never had one look like this it’s just perfectly down the center and all crisp lines? It does it no matter what and I’ve tried adjusting the picture but it never goes away. Update (04/07/2021) Ahoy Zeldie ; Not knowing anything about this ‘Chinese’ TV , regardless if it is plasma or led it would appear one of the multiplexing chips on the board across the bottom has gone bad ....

Chosen Solution What new Dell Computer is similar to the old Dell Inspiron 530S? Hi, What aspects from the old PC are you interested in having in the new PC? Here’s an overview of this model. Alternatively you could always look here I would say anything with a Core i3 processor for the Core 2 Duo variants (E7/E8) - I’m sure the i3 will even beat the E8 series chips, but some of the E8 SKUs stood their ground for so long you had to wait years for them to be dethroned in benchmarks and comparative performance....

Chosen Solution When taking a photo the camera delays between pressing the release and the picture being taken. I have set the camera to completely manual, exposure and focus, and it still delays. It appears to start doing this after warming up. Is this a processor problem or another part? If this is an inexpensive repair then I would do it. Any advice would be helpful. Check your settings again to make sure auto focus and focus assist are disabled....

Chosen Solution I want to replace my unibody bottom plate with a ventilated one (preferably one with pre-cut holes), such as many windows laptops to reduce heat. would this help? or just provide excess airflow that might block the existing flow and raise the temperatures even more You can definitely buy a new one, but the only i can find is 200$ (on Ebay). But another solution could be installing a fan-speed controller program on your Mac, and configure when the fans should turn on, and how powerful they should be....

Chosen Solution so i am testing this ipad pro and tried connecting to the charger nothing comes up , connected to usb to my pc and still does not pop on my pc.also tried the combination of volumen and hold power to turn on with no luck. what other stuff can i test? Make sure your cable is good (try different cables or power sources) and make sure that the cable sits flush into the port, if not, there may be some debris preventing the cable from makling good contact....

Chosen Solution I am turning of off/on switch, but the camera is still not turning on. I also can’t find the compartment where the batteries go. Look at the bottom of the camera for the battery compartment. Slide arrow to open it and put batteries in it in correct position. go to Sony SLT-A57 Troubleshooting mine will not turn on either i have changed lens also new batterie full charge and is turned on have done all recommended nothing works

Chosen Solution Hello all, the vibrator from my phone galaxy a9 2018 works for about 20mins after a restart then stops. This is very annoying. Is this common issue? tonelbg300 that should be a relatively new phone. Before you tear into it etc. you do want to go ahead and check the warranty status first. If it is under warranty get it replaced. After that you need to check the board according to the flowchart

Chosen Solution Hello everybody, i’m sorry for my english, I’ll try to be as explicit as possible. I’ve an iMac 21.5" emc 2308 and last friday my Hitachi 1 tb Hard Disk “died”. I’ve bought a western digital 1tb green HD, and the ifix guide for the HD replacement, about “thermal sensor” write down: “During reassembly, be sure that the thermal sensor connector is connected to set of pins closest to the SATA connectors”....

Chosen Solution I have a Red blinking light on my Laptop and my computer will not start. How long should I keep it charging. The red blinking light has continued for a couple of days and won’t start? It’s a Thinkpad 2 Lenovo What does that mean? Should I continue charging. I want to also assure that I’m not wiped out on my computer. How may I assess the programs if repair is needed?...

Chosen Solution I tried to reset my calibration in the settings but something went horribly wrong because now it’s way way off. Any way to fix it? I can not even get through the password screen because of how bad it is. You have probably fixed this by now (or thrown the device out) but if you can get an OTA cable and connect a wireless keyboard and mouse (logitich etc) you should be able to use these to log in and re-run the calibration tool....

Chosen Solution My touch screen does not respond to my finger. It only works with the key board. What do i do? Hi My screen was erratic also but came to a point where only the keyboard would work I have just followed the instructions on the link below to the point of disconnecting the battery from the motherboard (now that’s a hard reset lol) and reconnected after 15 minutes or so....

Chosen Solution After screen replacement my touchscreen isn’t working any more! Anyone any tips or tricks on that one? Screen is working fine! I agree with Scott’s answer above, but I’ll bet it’s the flex cable that has torn. I found it quite challenging to thread both the display and digitizer ribbons through the slot in the phone body and attach the screen panel to the body as well. Only after I had the screen seated (on the fresh double-sided adhesive) and the retaining screws tightened, I discovered that the flex-cable of the digitizer didn’t allow its connector to reach its corresponding site on the logic board....

Chosen Solution Obligatory not my Macbook. Helping someone. Said after he updated to Mojave it was having issues. Now it’s effectively stopped working most likely brought on by the most recent update. I’ve tried SMC reset, PRAM reset, safe mode, even installed another SSD and did a fresh install. I’m able to get into the boot menu with the onboard keyboard but after that it’ll stop working. Trackpad doesn’t work at all....

Chosen Solution So Yesterday while using my MacBook Air all of a sudden my trackpad and keypad stop functioning. I restarted the system and it started searching for a bluetooth keyboard. I looked online and seemed like a common issue and the common solution was opening the laptop and look for lose cables or change the logic board however I feel this is not the right solution in my case. I have a dual boot system since few months I’ve got MacOS & Ubuntu....

Chosen Solution I have a chevy 700r4 trans, will it connect to my chevy 350 @boldenasa , Asa Bolden, Yes the chevy 700r4 trans will connect to chevy 350. For spec’s and probable modification’s use the links below. Good luck. I hope this helped you out, if so let me know by pressing the helpful button. http://www.oldengine.org/unfaq/leadfoot/… http://nastyz28.com/forum/threads/my-th3… http://www.hotrodders.com/articles/TH-70… http://www.classicheartbeat.com/forums/s…

Chosen Solution Red light is on. TV won’t start unless I unplug the power cord from the outlet, wait 20 seconds and then replug it into the electrical outlet. Then it is fine. This process must be followed each time it is turned off in order to start again. Hi @esmerelda, Just trying to eliminate a few things When you turn it on and it doesn’t turn on, does the TV power light change colour at all?...

Chosen Solution Hi! I was literally just using my mp3 player and as the battery went low, I went to charge it, and the charging port pulled out the charging jack piece and i don’t know - can i reattach it? Is all lost? Thank you! Hi @ecrayons You may be able to solder it back onto the board. Here’s the ifixit Repairing Loose Headphone Jack guide that will help. It shows how to open the player so that you can access the board and resolder the USB port back on....

Chosen Solution Hey gang. About a year ago, my GF dropped her iPhone SE in water, and her AppleCare replaced it with a ‘“new” iPhone SE 1st gen, whatever that means (probably refurbished?) On this replacement SE, this morning after a call, the right half of the screen stopped responding to touch input. I also just noticed some vertical gray bars starting to appear on the very top of the screen (see attached image), mostly on the right half....