Posts

Chosen Solution The backlight fuse has blown on my 2011 MBP 17, so I am looking into replacing it. Does anyone know what fuse I should be looking for? This is a picture of the fuse in question: https://imgur.com/a/qMHUs7g Is it feasible for a non-expert solderer to replace this fuse, or should I be looking for help? Update (05/17/2018) Ok so I have removed the old fuse today (red contacts on photo below), however the component right next to it (green contacts on photo below) also came with it....

Chosen Solution So I have a 1992 k1500 5.7 tbi I bought from a friend, had a fuel problem creating a decent loss in power and stalling in low idle range as well as when the truck was coasting, replaced the fuel filter and MAP sensor which helped a little, stopped it from stalling at low idle range for the most part and no longer stalled while coasting, was going to replace fuel pump but fuel pump relay as well as fuel filter had been brand new so I I’m assuming fuel pump is as well since some work had been done to it prior to me getting it, I then proceeded with replacing spark plugs, wires, distributor cap and rotor as well as ignition coil, which leads me to how the truck is now, it acts as if it’s misfiring and runs incredibly rough, I have to hold the throttle open to even get it to start, I just finished rebuilding the throttle body and replaced the fuel regulator inside, no change at all, iv triple checked my wires and they all go to the correct places, spark plugs properly gapped and everything properly connected, no clue what my problem could be, any help is appreciated...

Chosen Solution What’s all this about apple joining ifixit? Fooled me. I panicked and downloaded the whole site with SiteSucker and DeepVacuum, with only partial success. Easy…. Aprils fool :-) Funny. They had me for a bit Lol I was like what a bunch of sell outs .. Silly me tho

Chosen Solution GE Profile water dispenser is leaking water out onto the floor. Here is a helpful answer to the same question. slow drip from GE smart water cold spout

Chosen Solution My 11” MacBook Air (2013) recently died and I have opened it up and removed the blade SSD. Beyond buying an older MacBook Air and connecting the SSD into it (I don’t have the money for that), does anyone recommend any USB adaptors I can connect it to? First Apple uses a custom SSD so you need a special case to hold it: OWC Envoy Pro Portable, Bus-Powered USB 3....

Chosen Solution I need a replacement motherboard for a gba but I only ever see motherboards for the gba sp. Does anyone know where I can find one? Your best is to find a Gameboy Advance on eBay or locally like FB Marketplace or CraigsList.

Chosen Solution Where can I find the board with the charging port my port went bad and I have the xt1955-5 which has 2 antenna connections and I cannot find the correct part for this variant i have the same problem. its frustrating im on day 6 now looking anywhere and everywhere online for the same item…..and the only one i’ve found is on eBay for $62 dollars and some change....

Chosen Solution On this issue I have changed the battery. Tried a few times power and volume up also by pushing on the home button. On some trys it sounds like when it takes pictures. On some tries it just flashes the logo. The new battery is now charged to 85%. I know the % cause I’m charging thru my computer. Has anyone gone thru this? Wife has same one and same problem....

Chosen Solution I have had this tablet for multiple years, and recently the WIFI on it has started to randomly disconnect. The internet my family has is pretty strong and this problem is only affecting my tablet, my phones and laptop are perfectly fine when it comes to the wifi. I tried multiple solutions online, but IDK if I have tried all the solutions. I even tried the simplest solution and turned off my wifi and turned it back on, but it didn’t work....

Chosen Solution Hi! I got a netbook from my grandmother from Paris that was given by the one who she is working for and then few months later, when I’m going to use it wrote “Preparing Automatically Repair” Then I just wait cuz I thought it was normal. After that while loading it wrote “Diagnosing your PC” then I was ready to panic until the blue screen showed. What I’m asking is how to fix it without windows installation…I mean it’s okay if the only way is to reset it…....

Chosen Solution how to get the tv to turn on 1)plug into the power outlet. 2)press the power button on your t.v. 3)press the power button on the remote control(if the remote control does not work,change the batteries) That’s it

Chosen Solution The touch id of my iphone 6 suddenly not working but the home button is working i don’t know what to do because it suddenly not working but when my battery is drained and turn off then i charge it and i open it , the touch id is work again then the time goes by when i sleep the phone then i open it again the touch id is not working again then i repeatedly restart/reset/hard reset nothing happen...

Chosen Solution Hello, I’ve replaced my WiFi antenna, WiFi works well but during the disassembly I’ve torn the flex cable which I connect to the board. Since I can’t find iPhone 6S Plus home flex cable, do I have to buy whole LCD with the cable or is there any other model that fits iPhone 6s Plus If you aren’t concerned about losing Touch ID functionality you are better off just getting a new home button....

Chosen Solution Hi guys, basically I smashed my iPhone 6 about a week ago I replaced the screen but in the process I tore the Touch ID extension flex that runs behind the LCD. I ordered a new flex cable from eBay and installed it. Home button now works flawlessly but Touch ID does not. Now when I try to setup a fingerprint it does not say failed or anything, it just acts as if it does not know that I’m touching the sensor....

Chosen Solution My son dropped his phone in water and grabbed it right out. We set it to dry and it mostly works. The problem is some spots on the touch screen are unresponsive and the brightness of the screen is really dim until he is on it for awhile and the brightness comes back. What do I need to replace??? Hi, First thing to change is the screen. You might have some damage on the motherboard, we could only help you with very HQ close-up pictures....

Chosen Solution Is there way to see the part number on the trackpads? I have a 2018 trackpad that I wanted to swap with a 2017 I have. Physically it will work size wise and ribbon cable wise but not sure if they are the same parts on the them, don’t want to screw up anything on the boards. Thanks! Too soon to tell what the part numbers are or if they are interchangeable....

Chosen Solution Where will I will be able to purchase the toolkit necessary to take the device apart? lareisa, best toolkit for all those devices would be this one. It will have all the screwdrivers and other tools needed to work on your HTC as well as many other devices.

Chosen Solution Power is showing in tester but usb not workin error is Your usb exeedin power limit Hi there, Under some computers, USB devices are only allowed to draw a maximum of 500 milliamps (mA) per connection from the USB port on the computer system or from a USB hub. If a device attempts to draw more than that (500 milliamps), a USB port balloon message is displayed to indicate this over current condition....

Chosen Solution My unit isn’t exactly shown in post. It is a Pioneer “elite” VSX-xxxx unit. Fairly new. If i turn the volume knob the unit turns off, then if i turn it back to a certain position unit comes back on. Using a remote has no effect on it so everything is ok so far… It seems like the unit is shorting out when turning the knob… Does anybody know what part could be faulty?...

Chosen Solution Model number 55SL412U 12V. 60Hz. 1.2 Amps max TV volume was all the way up at 99, then my mother pressed the volume down button and it made a loud pop, hasnt worked since. The stand by light does come on. But nothing else. Screen is completely black. No sound or anything at all. Update (01/02/2023) Picture of back of tv where something seems to have blown, toshiba tv, 55 inch I think, several years old, thanks to anyone who can help!...